Frame Fixin'

I'm working toward having my trailer campable by next June for the Wally Byam Birthday Bash in Central NY. I decided I better get moving or I'll never make it in time. So, today I got my butt in gear and got to work. This is where I left off after I cut out the rotten frame cross member and support plate.

I went to my local steel retailer, Steel Sales, in Sherburne, NY. They have a "drop room" that they'll let you poke around in. I was lucky and found a piece of 4 inch c-channel and a 24 x 12 inch piece of steel plate. Perfect! $17.00 later I was on my way. First thing I did back at the trailer was to fit a 2x4 piece of wood in where the cross member will sit so I could be sure to get the angles on the main frame rails set. The angle is 22.5 degrees, just in case anybody else is going to be doing this work.

Next, I transfered the angles from the wood onto the c-channel and cut it with the chop saw. This tool is indispensable for any kind of steel work. I cannot imagine making those cuts with a hack saw.

I was going to try to re-use the support plate, because it has so many holes that need to be aligned with the holes that are already in the skin of the trailer. Unfortunately, the plate was just too far gone. Also, I did not realize when I started that the plate actually goes all the way to the bottom of the c-channel and is not just welded along the top. In order to transfer the holes precisely, I tack welded the old plate to the new plate and used the old holes as a guide for drilling my new holes. Once I was done drilling, I carefully ground off the tack welds and I had an exact duplicate of the original plate.
Here is the almost finished piece, all mocked up. The next step will be to Klecko the plate to the skin of the Airstream, tack weld the frame cross member in place, and then once everything is lined up I'll tack weld the plate to the cross member. Then I'll grind the tack welds off the frame so I can bring the entire piece into the shop and weld it up solid. I don't want to weld it solid with it on the trailer, since I'm afraid the heat will hurt the aluminum skin. Once it's all welded solid, I'll do the final installation and welding of the new frame cross member / support plate onto the frame. Oh, I'll also cut the bottom inch of steel off the support plate that sticks down below the c-channel so it looks better. I needed a piece of steel plate that's 24 x 11, but the closest I could find in the drop room was 24 x 12. That's OK. I'll get my cutting wheel out and smile the entire time thinking of the money I save by not having Steel Sales cut me a piece to size.